Feig Electronic OBID i-scan D ISC.MU02.02 Installation Manual

Contents

Feig Electronic OBID i-scan D ISC.MU02.02 Installation Manual Manual pdf 17 page image

OBID® i-scan Montage ID ISC.MU02.02FEIG ELECTRONIC GmbH Page 17 of 36 M91002-0de-ID-B.docD E U T S C H4.2. USA (FCC)FCC ID: PJMMU02This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwo conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that maycause undesired operation.NOTICE:Changes or modifications made to this equipment not expressly approved byFEIG ELECTRONIC GmbH may void the FCC authorization to operate this equipment.This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-sonable protection against harmful interference in a residential installation. This equip-ment generates, uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio com-munications. However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or television recep-tion, which can be determined by turning the equipment off and on, the user is encour-aged to try to correct the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.This device is labeled with an FCC ID number.If this label is not visible when installed in an end device, the outside of the device MUSTalso display a label referring to the enclosed module.Wording on the label similar to the following shall be used:This device contains transmitter module FCC ID PJMMU02At the time of this printing, the antennas listed below were the only antennas approved foruse with the ID ISC.MU02.02 module. Use of other antennas must be approved byFEIG ELECTRONIC GmbH.Antennas approved: ID ISC.ANT.U170/170-FCCID ISC.ANT.U100/75-FCCID ISC.ANT.U75/50-FCC