FeherGuard FG-AR Assembly Instructions Manual

FeherGuard FG-AR Assembly Instructions Manual Manual pdf 1 page image

STEP 2: TUBE ASSEMBLYSTEP 1: SOLAR REEL PLACEMENT:ASSEMBLY INSTRUCTIONSAUTO REELAutomatic RollupFG-ARPLEASE READ ENTIRE INSTRUCTIONS CAREFULLY BEFORE PROCEEDINGREEL SYSTEMS COMPONENTS AND PREPARATION:Getting started:Ensure that your system has two cartons consisting of one end carton andone tube set carton.Tools required for assembly:· Portable drill· Tape measure· Pencil and ScissorsTube Carton Parts List:2 end tubes and 1 center tubeAUTO REEL Parts List:1 Bracket End1 Handle1 Bearing2 Plugs for L16M, L18M & L20M Tubes1 Water Discharge HoseHardware Kit: 10 Strap Plates10 Straps 10 Plastic Screws29 Self-drilling Metal ScrewsA.B.Determine the best location for the reel system. The widest point of the pool is the preferred locations (see Fig. 1 below).At the determined location, measure the width of the pool and add 6“ (15 cm).Ensure minimum of each end tube is inside center tube (see table below right).Less than minimum insert causes screws to loosen and/or tubes to split.Insert both end tubes equal distance into center tubeand mark on center tube where inner tubes endFig. 2Fig. 1A.Recommended Solar Cover is 12 mil with round bubbles.Allow an extra 4“ (10 cm) on cover length if installing the reel at mid-point or off-center.Before starting assembly, trim cover so it does not touch the sides of your pool when rolling up.Above-Groundpools with deckInsert Width Cover CoverTube Min. Max. Max. Wet Max.WeightL18M 9“ 18’6“ (5.7 m) 60# (27.3kg) 18x36L20M 12“ 20’6“ (6.3 m) 60# (27.3kg) 20x40L16M 9“ 16’6” (5.0 m) 60# (27.3kg) 16x32··Mill tubes tarnish over time. This does not affect tube integrity.Four Easy Steps:If you need additional assistance, contact us at info@feherguard.com or call 905-876-4766 Monday to Friday 8:30 a.m. to 5:00 p.m. Eastern Time.Recommend Safety Glasses1 Auto EndOptional Locking Casters are available: Part Name FG-CK1Lock tubes together by rotating the center tube in the opposite direction to end tube. HOLD TUBES LOCKED WHILE YOUINSTALL FIRST SELF-DRILLING SCREW ON A DRILL LINE, 1“ (2.5 cm) back from end of center tube at Location ”C1”(see Fig. 3 & 4).Place 2 more self-drilling screws at Location “C2” & “C3” - 1 screw at every second drill linearound tubes (see Fig. 3).At “D” locations install 3 screws around the center tube at every second drill line, 1“ (2.5 cm)back from where you marked the end of the inner tube from Fig. 2A (see also Fig. 3).Repeat for other end tube.B.C.D.E.C3End tube End tubeCenter tubeCDC1C1Drill lines DO NOTline up whentubes are lockedTubes Must be in Locked PositionDrill Lines DO NOT line up when tubes are lockedD2D1D1THIS STEP REQUIRES A TOTAL OF 12 SELF-DRILLING SCREWS DO NOT pre-drill holes or over-tighten screws.C2Fig. 3 D3 Fig. 4End Tube End TubeCenter Tube

/ 4

Related manuals for FeherGuard FG-AR