Federal CRR4828 Installation & Operation Instructions

Federal CRR4828 Installation & Operation Instructions Manual pdf 7 page image

- 7 -DANGER: Electric shock hazard. Do not operate unit with panels removed.1. Remove the (8) screws holding the rear frame panel located under the door track and also removethe 7/8” hole plug located next to the controls in the control panel.2. Disconnect the power cord connections and move the cord and cord strain relief from the bottomhole in the frame channel to the hole in the control panel and reconnect power cord. Plug bottomhole in frame channel with the 7/8” hole plug removed from the control.3. Reinstall the rear frame panel.Refrigerated CRR Self Contained ModelsCabinet PreparationThe CRR Self Contained models have a large condenser compartment hanging from the rear of the unit thatcontains the condenser/condensate evaporator unit. This compartment hangs off the rear edge of thecounter. The rear of the counter must be open to allow space for this compartment. The countertop topshould be flush with countertop back and the first top 8” of cabinet back must be flat with no doors.DANGER: Case must be fastened to counter and counter must be fastened to floor.IMPORTANT: The condenser air inlet and discharge louvers are located in the rear of the case. Do notblock these louvers and do not locate them near a source of heat. Clearance of 8” minimum must bemaintained for condenser air exchange.(2) ½”dia. case fastening holes will need to be drilled through the counter top surface to attach case tocounter with ¼” X 2” screws provided. Use the diagram below for hole placement location.IMPORTANT: When placing cases in a line up the number of end panels used will be different. The cutout and hole placement dimension will need to be adjusted for each particular line up circumstance. SeeLINE UPS INTALLATION section of this manual.25.25 MIN.10.0DOORS ON REAR OFCABINET MUST BE10.0" FROM COUNTERTOP SURFACECOUNTER TOP MUSTBE FLUSH WITH REAROF CABINET.IMPORTANT:UNIT MUST BEFASTENED TOCOUNTER ANDCABINET MUSTBE FASTENEDTO FLOOR36.0 (36"UNIT)48.0 (48" UNIT)21.93(2) 1/2" DIAMTG. HOLES31.0 (36"UNIT)43.0 (43"UNIT)CORD LOCATIONSTANDARD OPT.1CORD LOCATION OPT.21-1/2" DIA HOLE12.87 (36 UNIT)18.87 (48 UNIT)BACKCUTTING BOARD2.753/4" ENDPANELSCUSTOMER SIDETYPICAL CABINET CRB MODELSFRONTFRONT29.005.21 /6.71 SSCASE TOP VIEWEDG OF COUNTER TOP