Falcon Canopy hood Instruction Manual

Contents

Falcon Canopy hood Instruction Manual Manual pdf 20 page image

EN 2020• Place the other wall bracket 1 against the wall, aligning it with the vertical line at a distanceX, measured as shown in fig. 2, equivalent to the height of the U-shaped upper section Sprovided with the hood. The position X may vary, according to the various sizes of upperchimney element available.• Mark on the wall the centres of the keyholes for wall bracket.• Pilot drill all the holes marked, using an 8 mm drill. Fix the wall brackets 1 and the ringsusing the 8 mm rawl plugs and screws provided.Splashback (optional)When a splashback is to be fitted, the distance between the cooker hood and the cooking appli-ances will be determined by the height of the splashback B and of any raised back on the bot-tom units. The splashback is to be installed before installing the canopy. If the splashback is tobe fixed to the wall using both the top and bottom fixing holes care must be taken to ensurethat the splashback is fitted at the correct height before fixing it into position. The fittingshould be undertaken by a competent person with experience in this type of installation. If thesplashback is to be fixed through the top fixing holes only, proceed as follows:• Put the splashback on the worktop as illustrated (fig. 2b), then hold it against the wall, en-suring that it is correctly positioned.• Mark the holes for the top fixing screws on the wall.• Pilot drill the wall using an 8 mm drill and fix the splashback using the 8 mm rawl plugsand screws provided.• If the fixing holes in the bottom of the splashback are not to be used to secure the splashbackto the wall the installer should ensure that the bottom edge is tucked down behind the rear ofthe worktop.Fixing the canopy• Fasten the angle iron L to the hoodcanopy C (fig. 3) using the five 2.9 x9.5 screws provided. If a ducting ver-sion of the hood is to be used, ensurethat the two holes 1 are left open, asthese will later serve to connect theevacuation spigot A.• Hook the hood canopy C to thelower rings (fig. 4).• Remove the metal grease filters (seeparagraph Maintenance).• Vertically adjust the canopy andalign it horizontally b y turning thescrews V1 (fig. 5).• Turn the screws V2 until the hood istightly locked against the wall (fig.5).A01_05 Fig.3Fig.4Fig.5