Menu
Fairway rider G3 Operation And Maintenance Manual
            | |
© 2015 Fairway Rider G3 Ltd - Unit 20, Ravenhurst Court, Birchwood, Warrington, WA3 6PNWorkshop and Technical Support: 07495 063 014 | Email: enquiries@fairwayrider.co.ukBrake pad replacement Remove caliper assembly from buggy by undoing 2 x 8mm; NB do not remove the hydraulic pipe; Press the caliper mounting bracket in the direction of the arrow in thediagram ie towards the cylinder piston; Brake pad no. 2 has two lugs which locate it in position in the mountingbracket; as the mounting bracket moves down, the pad should emergefrom the caliper. If it does not, lever it upwards from the underside of themounting bracket; Once pad no. 2 is removed, and the bracket is fully pressed into thecaliper, pad no.1 can be removed. It may need to be twisted to removefirst from one mounting pin; Once removed from one pin, the pad will swivel to allow removal fromthe second pin; Replacement of new pads is the reverse of the above instructions.Brake cut-out switch replacement The switch is located underneath the brake lever, and has two spadeterminals connected to it; Remove the two spade terminals; Remove the small cross headed screw which holds the switch in position; Install the new switch, fastening the screw, and replacing the two spadeterminalsBrake lever replacement The brake lever pivots around a pin which has a screwdriver slot in itstop, and a 10mm nut at the bottom; Hold the pivot bolt in position with an appropriate flat-bladedscrewdriver, and undo the 10mm nut; Remove the pivot bolt, retaining the parking brake button assembly, anddiscard the old brake lever; Reassemble using the new brake lever; Take care not to over-tighten the 10mm nut as this may result in thebrake lever being stiff to use, and not releasing automatically after use. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved