FCI ST100 Series Configuration Software Manual

Also see for ST100 series: Installation, operation & maintanance manual Configuration software manual Manual Operation manual

Contents

FCI ST100 Series Configuration Software Manual Manual pdf 12 page image

ST100 Series Configuration Software8 Fluid Components International LLCConfiguration Tab ScreensSelect the Configuration branch on the menu tree. The Output Tab is the first of several tabs across the top of the screen. Each tab provides aparticular menu within the Configuration branch.The table below summarizes the tabs within the Configuration branch.Table 3 – Configuration TabsTab Name Tab Description Password LevelOutput Sets: 4-20 mA channels zero and span values, Freq and Pulse parameters. User4-20mA User Manual mA Output loop check; configure/enable NAMUR fault. UserModbus Sets Modbus communication parameters. UserExtended Op. ModeExpands flow measurement capabilities by providing 4 additional modesof operation. Refer to “Extended Operational Modes” in Complete Manual06EN003400 for detailed information.UserGroup Switch SetupSets up automatic calibration group switching depending on specific pro-cess data values or an external 4-20 mA output driving the ST100 auxiliaryinput port. Refer to “Auto FE Calibration Group Switch (FCS)” and “Exter-nal Control Group Switching (EGS)” in Complete Manual 06EN003400 fordetailed information.User[User password 2772]To verify the current configuration of any setup parameter, click the Get from Device button on any of the Setup menus. After changing any of thesetup parameters, click the Send to Device button. Verify the parameter change by clicking the Get from Device button again. Observe that thechanged parameters are now displayed. The Configuration Tab screens are shown below.Figure 16 – Example Output Tab (Configuration)