OneStart

Menu

FCI CHG-120 Instruction Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Contents
  1. instruction manual
  2. installation precautions
  3. Table Of Contents
  4. Introduction to the Charger
  5. Specifications
  6. Installing the Charger
  7. Installation Standards
  8. Connecting AC Power to the Charger
  9. Connecting Batteries to the Charger
  10. Mounting the Charger
  11. Mounting the Charger into a BB-55 Battery Box
  12. Connecting the Charger to a Load
  13. Adding the Charger for Additional Current
  14. Configuring the Charger
  15. Trouble and Form-C Relay Connections (Optional)
  16. Installing Optional Meters
  17. Operating the Charger
  18. Normal Operation
  19. limited warranty
FCI CHG-120 Instruction Manual Manual pdf 16 page image
Installing the Charger Connecting the Charger to a Load10 CHG-120 Instruction 11/22/04 PN: 52459:A FCI P/N:9000-0572Connecting the Charger to a LoadThis section provides two applications for connecting a charger to a load. While connectinga charger to a load, observe the following precautions:• Make sure all power sources are off to the charger and the load.• Follow polarity when making connections.Connecting the Charger to a Multiple Load You can connect a charger to multipleloads, such as a main power supply, auxiliary power supply, amplifiers, and so forth, asshown in Figure 9.Figure 9 Typical Wiring for a Charger to a Multiple LoadTo connect a charger as shown in Figure 9, follow these steps:Step Action1 Connect the battery+ and battery– terminals of the power supply to the chargeroutput circuit (TB2: Out 1+ and Out 1–) as shown in Figure 9.2 Connect the battery+ and battery– terminals of the amplifier to the chargeroutput circuit (TB2: Out 2+ and Out 2–) as shown in Figure 9.3 Connect the batteries to the charger (for battery connections see Figure 5 orFigure 6).CHG-120Generic AudioAmplifierPower SupplyNote: Figure 10 shows awiring diagram for tying theload to battery terminals toobtain additional current. Forexample, the first AA-120draws 7 A, the daisy-chainedGeneric Audio Amplifiersdraw 7 A, and the secondAA-120 draws 7 A ofadditional current from thebatteries.
/ 24
This manual is suitable for:
CHG-120
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved