Menu
Epson S5U1C88816P Manual
                  |
S5U1C88816P MANUAL EPSON 1(PERIPHERAL CIRCUIT BOARD FOR S1C88816/8F360)1 INTRODUCTION1 INTRODUCTION1.1 S5U1C88816P OutlineThe S5U1C88816P board provides the peripheralcircuits other than the core CPU, for the S1C88816/8F360. Consequently, you should install it into theICE and use it as the emulator for the S1C88816/8F360 models.The S5U1C88816P is equipped with LEDs andterminals for monitoring the internal operatingconditions, I/O connection connectors for thetarget system and other appropriate devices.1.2 S5U1C88816P ComponentsWhen unpacking the S5U1C88816P, check that thefollowing goods are present:(1) S5U1C88816P board ....................................... 1(2) I/O connection cable (80-pin/40-pin flat type × 2) .. 2 sets(60-pin/30-pin flat type × 2) .. 1 set(3) I/O connector for target system (40-pin) ......... 4(30-pin) ......... 2(4) Cable for monitor terminal (10-pin) ................ 1(5) S5U1C88816P Manual (Peripheral CircuitBoard for S1C88816/8F360) (this manual) ..... 1(6) Warranty .......................................................... 1(7) Warranty registration card ............................... 1(8) Report on the factory test ................................. 1(9) Note for using .................................................. 11.3 S5U1C88816P External DiagramFig. 1.3.1 S5U1C88816P external drawingNote: Keep the JP switch on the S5U1C88816Pboard as it was set prior to factory shipment.In no case should you remove it or changeit.I/O #2I/O #1I/O #3MONITORVSVDLCDCSVDONOSCCVDC1RESETLCD4.5VLCD5.5VEXLCDHVLDMODEVDC2VDC0EPSONE0C88816/F360 Peripheral circuit boardPRC88816Mother board J2 connectorMother board J1 connectorRESET switchLEDVSVD volumeMonitor connector for LEDI/O#2 connectorI/O#3 connectorI/O#1 connectorMonitor pinsGNDOSC1CRVR3 (OSC3CR ADJ)VR2 (OSC1CR ADJ)OSC3CR∗ The name 'PRC88816' on thedevelopment tool is the oldname of the product. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved