Epson PowerLite 745c Quick Setup Manual

Also see for PowerLite 737c: Installation manual User guide User manual Operation guide Operation guide

2 Turn the focus ring to sharpen the image.Turn the zoom ring to reduce or enlarge the image.3 If your image looks like or , you’ve placed the projector offto one side of the screen at an angle. Place it directly in front of thescreen, facing the screen squarely.4 If your image looks like or , press the or buttons onthe projector to correct it.EPSON®PowerLite®737c/ 745cQuick Setup1 Turn On Your Equipment1 Connect the power cord to the back of the projector and plug the otherend into an electrical outlet.2 Remove the lens cover.3 Remove the battery cover on the remote control. Locate the batteriesthat came with the projector and insert them as shown. Then replacethe battery cover.4 To turn the projector on, press the red Power button on theprojector or the remote control. The projector beeps once, and theprojector’s Power light flashes green and then stays on.CAUTION: Before unplugging the projector...Shut the projector down properly:1. Press the Power button twice. Let the projector cool while thePower light flashes orange (about 20 seconds).2. Once the light stops flashing and the projector beeps, it’s safe tounplug the projector.How do you want to get images to the projector?• To connect to a notebook, see “If connectingto a notebook” below.• To project over an 802.11g/b network, see“If projecting wirelessly” on the back of this sheet.You must have installed the projector’s EasyMPTMsoftware and configured your projector andcomputer before you can project wirelessly.See your User’s Guide for instructions.• To give a presentation stored on a memory card,see Chapter 5 in your User’s Guide.If connecting to a notebook...1 Make sure you’ve turned on the projector and adjusted the imageas described in sections 1 and 2.2 Locate the computer cable that came with the projector. Connectone end to the projector’s blue Computer/Component Video port.Connect the other end to your notebook’s video-out port ormonitor port. If you can’t connect the cable to yourPowerBook ®, you may need to use an adapter. See yourPowerLite 737c/745c User’s Guide for instructions.3 Press the Source Search button on the projector until yourcomputer image is displayed.3 Choose aPresentation Method1 To raise the image, press the blue foot release button for the frontadjustable foot and lift the front. Release the button to lock thefoot in position.2 Adjust the ImageTurn overZoomFocusComputer cableWireless card

/ 2

Related manuals for Epson PowerLite 737c