Epson PowerLite 1810p User Manual

Also see for 1810p - PowerLite XGA LCD Projector: User manual Operation guide Product support bulletin Quick setup User guide

Contents

70 Maintaining the ProjectorThe life span of the lamp is about 2500 hours if the BrightnessControl setting in the Settings menu is set to High (default), and3000 hours if the Brightness Control setting is set to Low. Makesure you have a spare lamp handy if the usage hours on this menuare close to the life span of your lamp.Replacing the BatteriesReplace the batteries in the remote control as described below:1. Turn the remote control over.2. Press down on the tab on thebattery cover as you lift the coveroff.3. Install two AAA batteries,inserting the + and – ends asshown.4. Position the cover as shown, thenpress down until it snaps intoplace.cautionWhen replacing batteries,take the followingprecautions:■ Replace the batteries assoon as they run out. If thebatteries leak, wipe awaybattery fluid with a softcloth. If fluid gets on yourhands, wash immediately.■ Do not expose batteries toheat or flame.■ Dispose of used batteriesaccording to localregulations.■ Remove the batteries ifyou won’t be using theprojector for a long period oftime.