Publishing Discs 17Chapter 2Publishing DiscsIntroductionThis section guides you through the procedures for creating and printing CDs/DVDs.Note:For information on CDs/DVDs, see the following section.& See “Discs” on page 90.Turning power on/offThis section describes how to turn on/off power.Turning power on1. Connect the power cable.2. Press P power button until the power light flashes.Power light flashes in green, then stays on.Turning power offPress the P power button for more than 1 second. The power light will flash in greenthen turn off; then power is turned off.c Caution:❏ Fan will operate after turning power off, but it will automatically stop after 15 minutes.❏ If the product is operating, wait for 10 seconds after operation is stopped, then turn offpower.❏ The product may not be recognized by the computer when the power is turned back onwhile fan is operating. In this case, disconnect the USB cable and connect it again.Note’❏ If turning off the product while power on the PC is on, follow the procedure below. If the productis turned off without following the procedure, data in the PC maybe damages.1. If Total Disc Maker, Total Disc Monitor, or Total Disc Setup is running, close the application.2. Double click "Safely Remove Hardware" on the task tray.3. Select DVD drive on the product and select Stop.
