Epson FX-1180+ User Manual

Contents

3-8 Using the Control PanelManual feed wait timeThe printer is set to wait 1.5 seconds between feeding sheetsmanually, but you can change it to 1, 2, or 3 seconds if necessary.Buzzer (beeper)The printer beeps when an error occurs. If you don’t want theprinter to beep when an error occurs, turn off this setting.Auto CR (carriage return)This setting is available only in IBM PPDS emulation mode.When auto carriage return is on, each line feed (LF) code orESC J code is accompanied by a carriage return (CR) code so theprinter moves the next printing position to the left margin.When this setting is off, you must send a CR code after the linefeed code to move the printing position to the left margin.IBM character tableThis setting is available only in IBM PPDS emulation mode.When you select Table 1, hex codes 00H to 1FH and 80H to 9FHof the character tables are used for the control codes. When youselect Table 2, hex codes 00H to 1FH are used for the controlcodes and 80H to 9FH are used for characters.Bottom marginWhen the printer is in Okidata mode, you can change the lengthof the bottom margin (the area between the last printable lineand the bottom of the sheet).Line spacingWhen the printer is in Okidata mode, use this setting to changethe number of lines printed per inch.Paper out overrideWhen the printer is in Okidata mode, you can turn this settingon to disable the paper out function and print beyond thebottom margin. Then you can press the LF/FF button for eachextra line you want to print until you reach the bottom limit.