Menu
Epson EX7230 Pro User Manual
Also see for EX7230 Pro: Quick setup
                                                                                                                                                                                                                                  |
• The projector's buttons may be locked for security. Unlock the buttons or use the remote control toturn on the projector.• The power cord may be defective. Disconnect the cord and contact Epson.• If the projector's lamp shuts off unexpectedly, it may have entered standby mode after a period ofinactivity. Press the power button to wake the projector.• If the projector's lamp shuts off, the Status light is flashing blue, and the Temp light is orange, theprojector has overheated and shut off. Check the solutions for this light status.• If the power button on the remote control does not turn on the projector, check its batteries and makesure the Remote Receiver setting is turned on in the projector's menu, if available.Parent topic: Solving Projector or Remote Control Operation ProblemsRelated referencesProjector Feature Settings - Settings MenuProjector Light StatusWhere to Get HelpRelated tasksUnlocking the Projector's ButtonsReplacing the Remote Control BatteriesSolutions to Problems with the Remote ControlIf the projector does not respond to remote control commands, try the following solutions:• Check that the remote control batteries are installed correctly and have power. If necessary, replacethe batteries.• Make sure you are operating the remote control within the reception angle and range of the projector.• Make sure the projector is not warming up or shutting down.• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Releasethe button to wake the remote control up.• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with theprojector's remote receivers. Dim the lights or move the projector away from the sun or interferingequipment.• If available, turn off one of the remote receivers in the projector's menu system, or check if all theremote receivers were turned off.• If you assigned an ID number to the remote control to operate multiple projectors, you may need tocheck or change the ID setting (feature not available with all projectors).160 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved