Setting Up Serial CommunicationThe RS-232C Serial Communication Kit allows your computer and projectorto communicate so you can access the projector menus from your computerand use the remote control to control your computer. The kit consists of acable, a Macintosh adapter, and two software utilities: ELP Link and ELPRemote Programmer.Instructions for installing the cable and software are given in the next twosections. For information on using ELP Link, see Chapters 2 and 3. Forinformation on the ELP Remote Programmer, see Chapter 4.By default, the Serial setting in the Options menu is on to enable communicationwhen the Serial Communication Kit is installed. If, after installing the kit, youcannot enable communication, make sure the Serial setting has not been turnedoff. See Chapter 3 for more information about the menus.Connecting the serial cableTo connect the serial RS-232C cable to your computer and projector:1. Connect one end of the serial RS-232C cable to the projector’s RS-232Cconnector.2. If you have a Macintosh, attach the RS-232C adapter to the modem port onthe Macintosh.Setting Up Serial Communication 15
