Maintenance106Replacing the lampWarningWhen replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may bebroken. If replacing the lamp of a projector that has been suspended from the ceiling, you should alwaysassume that the lamp is cracked, and remove the lamp cover with care. When you open the lamp cover,small shards of glass could fall out. If any shards of glass get into your eyes or mouth, contact a doctorimmediately.Caution• Do not touch the lamp cover immediately after turning off the projector as it is still hot. Wait until the lamphas cooled down sufficiently before removing the lamp cover. Otherwise, you could get burnt.• We recommend the use of genuine EPSON option lamps. The use of non-genuine lamps may affect projectionquality and safety.Any damage or malfunction caused by the use of non-genuine lamps may not be covered by Epson's warranty.a Press the button on the remotecontrol or the control panel to turn offthe power, and then disconnect thepower cord.b Loosen the lamp cover fixing screw.c Remove the lamp cover.Slide the lamp cover straight forward andremove it.d Loosen the two lamp fixing screws.e Remove the old lamp.Grip the knob firmly and pull it straight out.
