Multi-part formsYour printer can print on both single-sheet and continuousmulti- part forms. You can load single-sheet multi-part formsonly in the front paper slot.You can use multi-part forms of up to four parts (including theoriginal). Make sure you set the paper-thickness lever to theproper position. Use only carbonless multi-part forms.You load multi-part forms the same way as you load singlesheets or continuous paper. For best results with continuousmulti-part forms, it is recommended you use the tractorinstalled in the push-tractor position together with the optionalpull tractor.For details, see “Using Single Sheets” or “Loading continuouspaper with the pull tractor,” earlier in this chapter. Pay specialattention to setting the loading position as described in “Usingmicro-feed” in Chapter 3.Caution:When printing multi-part forms, make sure the printingstays entirely within the printable area of the forms. (Formore information on the printable area, see Chapter 7.)Use four-part multi-part forms only under normaloperating conditions.Load single-sheet multi-part forms from the front only.Paper Handling 2-25
