Electrolux Wave-Touch 137018100 A Use And Care Manual

34 Solutions to Common ProblemsService Prevention ChecklistBefore calling for service, review this list. It may save both time and expense. The list includes commonoccurrences that are not the result of defective workmanship or materials in this dryer.OCCURRENCE POSSIBLE CAUSE SOLUTIONDryer does not start. Electrical power cord is not securely pluggedin or plug may be loose.Make sure the plug fits tightly in wall outlet.House fuse blown or circuit breaker tripped. Reset circuit breaker or replace fuse.Make sure electrical line is not overloaded and thedryer is on a separate circuit.Thermal limiter tripped. Call authorized service person for replacement.LCD displaysDEMO MODE.Dryer has been programmed to temporarilyperform a repeating demo cycle.To return to the factory default settings, select RESETin set prefs under the options scroll buttons.Dryer runs but won’theat.There are 2 house fuses in the dryer circuit. If 1of the 2 fuses is blown, the drum may turn butthe heater will not operate. (electric models)Replace fuse.Gas supply valve is not open (gas models). Check to make sure supply valve is open. See INSTAL-LATION INSTRUCTIONS for procedure.Dryer does not have enough air supply tosupport the burner flame (gas models).See INSTALLATION INSTRUCTIONS.LP gas supply tank is empty or there hasbeen a utility interruption of natural gas (gasmodels).Refill or replace tank.Dryer should heat when utility service is restored.Drying cycle takes toolong, outside of thedryer feels too hot orsmells hot.Lint filter is clogged with lint. Make sure all lint has been removed from the dryer lintfilter before starting each cycle.Exhaust duct requirements have not beenmet.Exhaust duct must be at least 4 inches in diameter andmade of rigid or semi-rigid metal.When in place, the duct must have no more thantwo 90° bends and must not exceed length listed inINSTALLATION INSTRUCTIONS.Electric dryer is connected to a 208 voltcircuit.Drying time will be 20% longer than drying on a 240volt circuit.Drying procedures have not been followed. See “Operating Instructions.”Outside exhaust hood or exhaust duct maybe clogged or restricted.Clean out any obstruction.High humidity. Use a dehumidifier near the dryer.

/ 36

Related manuals for Electrolux 137018100