Electrolux RH30WC60GS Installation, Use & Care Manual

Also see for 30" Electric/Microwave Combination Wall Oven: Use & care guide Installation guide Installation instructions Use & care guide Installation instructions

13Installing the hoodMaking the electrical connectionsElectrical Shock HazardWarning: Turn off at the service panel before wiringthis unit.120 V AC, 15 or 20 Amp circuit required.ELECTRICAL GROUNDING INSTRUCTIONSTHIS APPLIANCE IS FITTED WITH AN ELECTRICALJUNCTION BOX WITH À WIRES, ONE OF WHICHôGREEN/YELLOWÈ SERVES TO GROUND THEAPPLIANCE. TO PROTECT YOU AGAINSTELECTRIC SHOCK, THE GREEN AND YELLOWWIRE MUST BE CONNECTED TO THEGROUNDING WIRE IN YOURHOME ELECTRICAL SYSTEM, AND IT MUSTUNDER NO CIRCUMSTANCES BE CUT ORREMOVED.Failure to do so can result in death or electricalshock.Remove junction box cover and knockout on thetop left side.If not already done, install 1/2” conduit connectorin junction box.NOTE: This connector is not included with venthood.••Run black (live), white (neutral), and green(earth) wires (#14 AWG) according to theNational Electrical Code or CSA Standards andlocal codes and ordinances in 1/2” conduit frompower supply to junction box.Connect black, white, and green wires frompower supply to black, white, and green/yellowwires in junction box respectively.These connections should be done alwaysmaking reference to the electrical diagram foundinside the hood.Close junction box cover and reapply screws.••••Metal electricalconduitHousewiringUL listedwire nutJunction boxcoverKnockout