Electrolux GA60LIWE User Manual

Also see for GA60LICN: User manual User manual User manual User manual

Problem and alarm code Possible cause and solutionThe appliance does notdrain the water.The display shows i20.• Make sure that the sink spigot is not clogged.• Make sure that the interior filter system is not clog‐ged.• Make sure that the drain hose has no kinks or bends.The anti-flood device is on.The display shows i30.• Close the water tap.• Make sure that the appliance is correctly installed.• Make sure the baskets are loaded as instructed inthe user manual.Malfunction of the waterlevel detection sensor.The display shows i41 -i44.• Make sure that the filters are clean.• Switch the appliance off and on.Malfunction of the washpump or the drain pump.The display shows i51 -i59 or i5A - i5F.• Switch the appliance off and on.The temperature of the wa‐ter inside the appliance istoo high or malfunction ofthe temperature sensor oc‐curred.The display shows i61 ori69.• Make sure that the temperature of the inlet waterdoes not exceed 60°C.• Switch the appliance off and on.Technical malfunction ofthe appliance.The display shows iC0 oriC3.• Switch the appliance off and on.The level of water insidethe appliance is too high.The display shows iF1.• Switch the appliance off and on.• Make sure that the filters are clean.• Make sure that the outlet hose is installed at the rightheight above the floor. Refer to the installation in‐structions.The appliance stops andstarts more times duringoperation.• It is normal. It provides optimal cleaning results andenergy savings.The programme lasts toolong.• If the delay start option is set, cancel the delay set‐ting or wait for the end of the countdown.• Activate the TimeSaver option to reduce the pro‐gramme duration.• Activating options can increase the programme dura‐tion.The remaining time in thedisplay increases andskips nearly to the end ofthe programme duration.• This is not a defect. The appliance is working cor‐rectly.ENGLISH 51