Menu
Electrolux Frigidaire FFLE1011MW1 Installation Manual
                                             |
6INSTALLATION REQUIREMENTSExhaust system requirementsUse only 4 inch (102 mm) diameter rigid or flexible metal duct and approvedvent hood which has a swing-out damper(s) that open when the dryer is inoperation. When the dryer stops, the dampers automatically close to preventdrafts and the entrance of insects and rodents. To avoid restricting the outlet,maintain a minimum of 12 inches (30.5 cm) clearance between the vent hoodand the ground or any other obstruction.If your present system is made up of plastic duct or metal foil duct, replace itwith a rigid or semi-rigid metal duct. Also, ensure the present duct is free ofany lint prior to installing dryer duct.The following are specific requirements for proper and safe opera-tion of your dryer.WARNINGFIRE HAZARDFailure to follow these instructions can create excessive drying times andfire hazards.WARNINGFIRE HAZARDDo not install a clothes dryer with flexible plastic or metal foil ventingmaterials. Flexible venting materials are known to collapse, be easilycrushed and trap lint. These conditions will obstruct clothes dryer airflowand increase the risk of fire.CorrectIncorrect96”(244cm)max.33”(84cm)min.Drain system requirements1 Drain capable of eliminating 17 gals (64.3 L) per minute.2 A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.3 The standpipe height above the floor should be:Minimum height: 33 in. (84 cm)Maximum height: 96 in. (244 cm) |
Related manuals for Electrolux Frigidaire FFLE1011MW1
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved