15Door ReversalYour dryer is designed so the door swing may be reversed atany time without additional parts. Conversion is accomplishedby transferring hinges to the opposite side of the cabinet.To change the direction of the door opening:Open the dryer door. Remove the four hinge hole plugs from1.the left side of the door opening. Place nearby for futureinstallation.1234Replacement parts:If replacements parts are needed for your dryer, contact thesource where you purchased your dryer.- ELECTRICAL SHOCK HAZARD - Label allwires prior to disconnection when servicing controls. Wiringerrors can cause improper and dangerous operation. Verifyproper operation after servicing.You may need a plastic knife to help pull out theplugs. Be careful not to scratch the paint.Remove the four screws that secure the door hinges to the2.dryer front panel (see right).Rotate the door 180° and reinstall the door hinges to the3.dryer front panel with the four screws.Install the four hinge hole plugs in the open screw holes on4.the opposite side of the door opening.General installationConnect the exhaust duct to the outside exhaust system (see1.pages 4 through 6). Use of a 4” (10.2 cm) clamp (item A) isrecommended to connect the dryer to the exhaust vent system.Use metal foil tape to seal all other joints.Carefully slide the dryer to its final position. Adjust one or more of2.the legs until the dryer is resting solidly on all four legs. Place a levelon top of the dryer. The dryer MUST be level and resting solidly onall four legs. Rock alternating corners to check for stability. Removeand discard door tape.Plug the power cord into a grounded outlet.3.Turn on the power at the circuit breaker/fuse box.4.Read the5. Use & Care Guide provided with the dryer. It containsvaluable and helpful information that will save you time andmoney.If you have any questions during initial operation, please review6.the “Avoid Service Checklist” in your Use & Care Guide beforecalling for service.Place these instructions in a location near the dryer for future7.reference.Be sure the power is off at a circuit breaker/fuse box before plugging the power cord into an outlet.A wiring diagram and technical data sheet arelocated inside the dryer console.A