Electrolux EWS 1252 EDU User Manual

9.12 10.12.8 Emergency drainBecause of a malfunction, the appliancecannot drain the water.If this occurs, do steps (1) through (9) of'Cleaning the drain filter'. If necessary,clean the pump.When you drain the water with theemergency drain procedure, you mustactivate again the drain system:1. When you drain the water with theemergency drain procedure, you mustactivate again the drain system: Put 2litres of water in the main washcompartment of the detergentdispenser.2. Start the programme to drain thewater12.9 Frost precautionsIf the appliance is installed in an areawhere the temperature can be less than0° C, remove the remaining water from theinlet hose and the drain pump.1. Disconnect the mains plug from themains socket.2. Close the water tap.3. Put the two ends of the inlet hose in acontainer and let the water flow out ofthe hose.4. Empty the drain pump. Refer to theemergency drain procedure.5. When the drain pump is empty, installthe inlet hose again.WARNING!Make sure that thetemperature is more than 0°C before you use theappliance again.The manufacturer is notresponsible for damagescaused by low temperatures.13. TROUBLESHOOTINGWARNING!Refer to Safety chapters.13.1 IntroductionThe start of the appliance does not occuror it stops during operation.First try to find a solution to the problem(refer to the table). If not, contact theAuthorised Service Centre.With some problems, the acoustic signalsoperate. The red indicator flashes andone of the indicators comes on, to showan alarm code:• - The appliance does not fill withwater properly.• - The appliance does not drain thewater.• - The appliance door is open ornot closed correctly. Please check thedoor!ENGLISH 19