11 Electrolux 818 19 39--00/3Door Reversal1. Close the cabinet and remove the plug from theelectrical socket.2. Remove the ventilation grille. There is a part onthe grille that can be removed. Reposition it and putit on the other side.3. Put the cabinet on a wooden board when it is laiddown. Later, when raising the cabinet, it will beeasier to grip under the cabinet thanks to the board.4. On the upper part of the cabinet. Put the hinge pinon the other side.5. On the lower part of the cabinet.a Unscrew the hinge.b Remove the door-closing fittings from the hingeand put the hinge pin on the other side. Then attachthe supplied door-closing fitting.6. a. Remove the door-closing fitting from thebottom of the door.b. Remove the plastic plug from the correspondinghole on the other side. Use a screwdriver to rock theplug loose. Then secure the supplied door-closingfitting.c. Secure the lower hinge.Remove any play in the door by adjusting the heightof the lower hinge with the supplied spanner. Securewith the lock-nut.7. Raise the cabinet and replace the ventilation grille.8. To transfer the handle.Unscrew the screws. Fit the handle onto the oppositeside by turning it one half circle.9. Put the cabinet in position. Check that it standsstraight. See the section "Positioning the cabinet".Electrical connectionConnect the cabinet to a grounded electrical outlet.Voltage: 230 V.Fuse: 10 A.Refer to the rating plate on the left inside thecabinet.12345 a5 ba bc68