Menu
Electrolux EPWD15MB Installation Instructions Manual
        | |
CAUTIONEXCESSIVE WEIGHT HAZARDTo avoid back or other injury, have more than one person moveor lift the washer or dryer.C) Attaching mounting hardwareD) Mounting washer or dryerE) Installing or re-installing washer or dryerRock the pedestal from corner-to-corner to check for stability.3.Repeat leveling and rocking until all four (4) feet are sturdy onthe floor and pedestal is level.Without turning the rubber foot, lock each pedestal leg in4.place by tightening its lock nut tight against the pedestal base.Attach each front clip to outer-most set of holes with 2 screws.1.Using two or more persons, slightly tip the washer or dryer1.back and lift it onto the pedestal. Still tipped, slide the appli-ance back against the rear brackets and gently set down thefront so the appliance is between the front and rear brackets.Insert “C” tab of each rear bracket into the widest slots on rear2.of pedestal. Orient bracket outward for washer mounting (imageC2a). Orient bracket inward for dryer mounting (image C2b).Install 2 screws through each rear bracket into aligning pedes-3.tal holes.Adjust the appliance side-to-side to align its mounting holes2.with the pedestal’s bracket holes.Install 2 screws through each rear bracket into the base of the3.washer (image D3a) or dryer (image D3b).With the pedestal drawer open for better access, install a screw4.through each front bracket into the base of the washer or dryer.Slide appliance/pedestal into place.1.Check for levelness and rock all four (4) legs again. Repeat2.until level and solid.Refer to Washer or Dryer Installation Instructions for complete de-3.tails on installing water, drain, electrical, gas, or exhaust venting.C2a (WASHER)C3a (WASHER)D3a (WASHER)C3b (DRYER)D3b (DRYER)C2b (DRYER)lock nutSLIDE BACKTIP DOWNtab slottab slotoutwardinward3 |
Related manuals for Electrolux EPWD15IW
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved