Electrolux ELECTRONIC BASIC IH 18 Instructions For Installation And Use Manual

Contents

18Fault indications- L1 or L3 phase missing- L2 phase missing*) The individual fault are indicated every 5 sec. The indication mode startsafresh every 40 sec.Important! If the fault has been rectified, the fault memory goes automati-cally in Reset - Function.(Sometimes with cold water flow phase ca.15 sec.)Faultpattern Idicator Possible faultsLED 1 LED 21 No displayAppliance doesnot work- Flowrate sensor not plugged/ defectiveSetpoint temperaturenot reachd2 FLASHESlongFLASHESlong- Setpoint generator not fitted3No displaywarm water temp. 37°CConstantFLASHESlongFLASHESshortNo heat output- Electronics defectiveFLASHESlong ONNo heat output4 - Supply temperature over 25°C5 ONNo heat output- Water flow over 20l/min

/ 20

Related manuals for Electrolux ELECTRONIC BASIC IH 18