Electrolux ECH-1000 M EEC User Manual

6www.home-comfort.combetween 0.1 °C and 3 °C, depending onthe volume and thermal insulation of theroom / premises. We recommend thatwhen operating the device in large rooms/ premises subject to rapid cooling, set thetemperature 2 - 3 °C higher than the desiredone for more efficient operation of theheater.”Overheating protection” functionThe device is equipped with an automaticswitch that is activated when the uppertemperature limit is reached. The heaterswitches off automatically in case ofoverheating. After eliminating the sourceof overheating, the heater will turn onautomatically.Installation of the deviceThe device must be fixed in accordance withthe regulations.The switch and other mechanisms muststay away from splashing water. It is strictlyforbidden to cover or plug the air inlets oroutlets (grilles), due to the risk of accident ordamage to the device. Do not place behindcurtains, doors, wall or air vents. Observethe minimum installation distances on floors,surfaces, furniture, etc (Figure. 3).100 mmmin.100 mmmin.100 mmmin.Figure. 3Floor installationUsing the chassis (supplied separately), havingpreviously studied the mounting scheme (Fig.6), install the device on the floor:1. Carefully turn the convector upside down(Fig. 4).2. Take one of the chassis and attach to thelanding area on the right or left side of thePreparation for work1. Carefully remove the heater from the card-board box.2. Remove the colored stickers from the frontpanel before use.3. At the first start-up, some odor mayappear, which will disappear after the con-vector starts to work.4. Fix the device in a stable position accord-ing to the assembly and installation instruc-tions.5. After installing the convector, plug it into apower outlet. It is not recommended to usethe same electrical outlet for simultaneousplugging in heater and other high powerelectrical appliance.Turning on the deviceInsert the plug into a power outlet, the powerindicator will light up and stay on. Set theon / off button on the control unit to themode, or turn the thermostat control knobon the top panel to the right, so that thedevice starts working and you can select therequired heating temperature. If the ambienttemperature is lower than the set one, theconvector starts to work, if the ambienttemperature becomes higher than the set one,the device automatically turns off and goesinto standby mode, and then turns on againwhen the room temperature drops.Setting the temperatureTo set the required heating temperatureand maintain a constant room / premisestemperature, turn on the device at full power,turn the thermostat control knob to the right tothe maximum value.When the room / premises temperaturereaches a comfortable level for you, slowlyturn the thermostat control knob to the leftuntil you hear a click. Thus, the device willremember the temperature that is comfortablefor you and will maintain it by automaticallyswitching on and off.The difference between the on / offtemperatures for the set value can be