Electrolux 6000 series Service Manual

Also see for 7000: User manual Service manual Instruction book Manual User manual

Contents

953. Release the rivet holding the air bell to the outer tub.NOTE: Seal air connecting tube to air bell and airbell to sump hose using waterproof glue.DO NOT plug air connecting tube opening.Removing the tub assembly:1. Disconnect the washer from the electrical supplyand the hot and cold water hoses.2. Remove the top panel, console, rear access paneland the front panel.3. Disconnect the advance rinsing technology hosefrom the bellows, the detergent outlet and siphonbreak hoses from the outer tub.4. Remove the drain pump and disconnect the drainsump from the tub.5. If you are going to replace the front half of the outertub remove the bellows and the weight ring.6. Remove the small hose from the air bell.7. Remove the large pulley, drive motor and speedcontrol board assembly.8. Disconnect the bearing ground wire.9. Remove the top pins from shock absorbers and pushthe shock absorbers against the cabinet.10. Place something down to protect the floor, carefullyturn the washer on it’s face and release the springs.