Electrolux 34942G Operating Instructions Manual

21Permanent ConnectionIn the case of a permanent connection, it is necessary that you installa double pole switch between the hob and the electricity supply(mains), with a minimum gap of 3 mm. between the switch contactsand of a type suitable for the required load in compliance with thecurrent electric regulations.The switch must not break the yellow and green earth cable at anypoint.Ensure that the hob supply cord does not come into contact withsurfaces with temperatures higher than 50 deg. C.Wiring diagram1. TAPS IGNITOR SWITCHES2. IGNITOR UNIT21LN022024012345NReplacement of the cableThe connection of the voltage cable to the appliance's terminal blockis of type "Y". This means that its replacement requires the specificequipment of a technician.In this case, only cable type H05RR-F must be used. The cable sectionmust be suitable to the voltage and the working temperature.The yellow/green earth wire must be approximately 2 cm. longer thanthe phase wires.Electrical connections