Electrolux 30" GAS RANGE Installation Instructions Manual

Also see for #: Installation instructions Use & care guide Use & care guide Use & care Use & care guide

Contents

730" GAS RANGE INSTALLATION INSTRUCTIONSAB5. Adjust the "LOW" Setting of the Dual Burner(see Figure 8) on the Surface Burner Valve (Figure10):Note: On the dual valve the low setting of each portion(rear portion of bridge burner and the center portion ofbridge burner) should be adjusted individually.a. Push in and turn control to LITE until the rear portionof the bridge burner ignites only.b. Quickly turn knob to LOWEST POSITION.c. If burner goes out, reset control to OFF.d. Remove the surface burner control knob.e. The inner portion of the dual burner flame size can beincreased or decreased by turning screw A (see Figure10). Use screw B to adjust the flame size of the outerportion of the dual burner. Turn counterclockwisethe screw to increase flame size. Turn clockwise thescrew to decrease flame size. Adjust flame until youcan quickly turn knob from LITE to LOWEST POSITIONwithout extinguishing the flame. Flame should be assmall as possible without going out.Note: Air mixture adjustment is not required on surfaceburners.Figure 10Figure 94. Adjust the "LOW" Setting of Regular Burner (seefigure 8) on the Surface Burner Valves (Figure 9):a. Push in and turn control to LITE until burner ignites.b. Quickly turn knob to LOWEST POSITION.c. If burner goes out, reset control to OFF.d. Remove the surface burner control knob anddecorative ring.e. Insert a thin-bladed screwdriver into the hollow valvestem and engage the slotted screw inside. Flamesize can be increased or decreased by turning thescrew. Turn counterclockwise to increase flame size.Turn clockwise to decrease flame size. Adjust flameuntil you can quickly turn knob from LITE to LOWESTPOSITION without extinguishing the flame. Flameshould be as small as possible without going out.Note: Air mixture adjustment is not required on surfaceburners.