Electrolux 134700400 Installation Instructions Manual

Contents

11Snap one end of the drain hose hanger1.(shipped in washer drum) onto the drain hose.Continue wrapping it around the hanger andsnap it in place.Place the hook end of the drain hose in the drain2.opening. Secure the drain hose with the cable tie(provided in the enclosure package) to the stand-pipe, inlet hose, laundry tub, etc. so the hosedoes not pull out from the force of the water.Connecting drain and electricalInstallation InstructionsGrounding typewall receptaclePower cord with3-prong grounded plugDo not, underany circumstances,cut, remove,or bypass thegrounding prong.IMPORTANTCheck to ensure the power is off at a circuitbreaker/fuse box before plugging the power cordinto an outlet.Plug the power cord into a grounded outlet.3.Turn on the power at a circuit breaker/fuse box.4.Carefully slide the washer to its final position.5.Recheck for level and rock corners for stability.Remove and discard door tape.Read the6. Use & Care Guide provided with thewasher. It contains valuable and helpful infor-mation that will save you time and money.See the next page about performing a brief,7.helpful “Installation Cycle” on your new washer.If you have any questions during initial opera-8.tion, please review the “Service PreventionChecklist” in your Use & Care Guide beforecalling for service.Place these instructions in a location near the9.washer for future reference.NOTEA wiring diagram and technical data sheet arelocated under the washer top panel, on top of thedetergent dispenser housing.CABLE TIE