Electrolux 102 Use And Care Manual

Also see for 102 D: Specification sheet

Contents

8302 Model1 Door LatchThe latch is under the control panel at the top of the door.• Lift the latch handle forward to open door.Please note: The machine will not start until the door is properly closed and latched.2 Power on Button• Press the power button to supply power to the dishwasher.3 Program/Clear Button• Press the button repeatedly to select the program you want.• (See below for program cancellation.)4 Program Indicator Lights• The program indicator light for the program you selected will be on.5 Start/Pause Button• Press the start/pause button to commence the selected program.• Pressing the start/pause button again during a wash program will pause the machine,and a “P” will flash in the display.6 Delay Start Option Button• Press this button repeatedly for a delayed program start of 1 to 19 hours. The selectedprogram will start when the delayed time has expired.7 Progress Indicator Lights• The progress indicator lights show the progress and position in the program.8 Digital LED Display Window• This display will show the approximate wash time or the delayed start time.PROGRAM END• The “ready” light will be on.• The buzzer will beep for 2 seconds. The digital display will show “O” until you open/closethe door.PROGRAM CANCELLATION• A program can be cancelled during the wash cycle by pressing the program/clear buttonfor 3 seconds.CHANGING PROGRAMS• The selected program can be changed after starting that program by pressing the programbutton for 3 seconds to cancel that program, then select another program and press start.PROGRAM INTERRUPTION/PAUSING• A wash program can be interrupted by the following actions.• Pressing the start/pause button.• Opening the door.• Pressing the power button.• The wash program will resume from the point where it was interrupted.CHILD LOCK ACTIVATION• The child lock can only be set or reset in the program selection stage.• To activate the child lock, simultaneously hold the Program/Clear and Start/Pausebuttons down for 5 seconds• The child lock can be temporarily bypassed at any stage of the program by holding anykey for five seconds. It will remain bypassed for fifteen seconds after the last key is pressed.• CL is displayed when a button is pressed while the child lock is activated.• To deactivate, press the Program/Clear and Start/Pause for another 5 seconds.a. Control Panel