A Dell Deployment and Configuration GuideDell Networking S5000Switch Configuration Guide for SC Series iSCSI SANsDell Storage EngineeringFebruary 2016

Revisions

Introduction

Cabling diagram

Dell recommended switch configuration

Configure out of band (OOB) management port

Enable Jumbo Frames

Save configuration

Configure UPM ports as Ethernet Pass-through (Optional)

To revert Ethernet Pass-through to FC ports

Additional resources

Dell S5000 Configuration Manual

About this Guide

Unpacking the Switch

Hardware Installation Overview

Hardware Overview

Utility Panel

Port Numbering Convention

Site Preparations

Storing Components

Installation

Install the S5000 Chassis in a Rack or Cabinet

Rack Mounting Safety Considerations

Installing the S5000 Chassis into a 4-Post Rack or Cabinet

Installing an Ethernet Module

Replacing an Ethernet Module

Installing a Fibre Channel Module

Replacing a Fibre-Channel Module

Installing an AC Power Supply

Important Points to Remember for Installing a DC Power Supply

Assembling and Connecting the Safety Ground Wire for DC Power Supply

Installing a DC Power Supply

Installing the Ferrite Bead for DC Power and Return Cables

Securing Power Cables

Replacing an AC or DC Power Supply

Installing a Fan Module

Splitting QSFP+ Ports to SFP+ Ports

Connecting Two S5000 Systems

Supplying Power and Powering Up the System

AC Power

Technical Specifications

Agency Compliance

European Community Contact

Safety Standards and Compliance Agency Certifications

Product Recycling and Disposal

Technical Support

Contacting Technical Support

Networking S5000

hardware configuration

Configure Data Center Bridging (DCB) (Optional)

Configure DCB policies

Reverting from DCB to non-DCB configuration (Optional)

additional resources

Overview

B: Converged Network Solution - Dell PowerEdge Server, Dell PowerVault storage array, and Dell S5000 as NPIV Proxy Gateway

C: Using Dell S4810 or Dell MXL/IOA Blade switch as a FIP-snooping Bridge

D: FCoE CNA adapter configuration specifics

Creating a NIC Team

Dell QLogic QLE8262

product description

important points before you continue

hardware installation overview

utility panel

port numbering convention

attaching the mounting brackets

rack mounting safety considerations

rack grounding

installing an ethernet module

important points to remember for installing a fibre channel module

installing a fibre channel module

important points to remember for installing an ac power supply

installing an ac power supply

assembling and connecting the safety ground wire for dc power supply

important points to remember for installing a dc power supply

installing a dc power supply

installing the ferrite bead for dc power and return cables

securing power cables

important points to remember for installing a fan module

supplying power and powering up the system

performing the initial configuration

default configuration

technical specifications

Dell S5000 Configuration Manual

Product

Learn More

Legal


Contents Revisions Table Of Contents Introduction Cabling diagram Dell recommended switch configuration Configure out of band (OOB) management port Enable Jumbo Frames Save configuration Configure UPM ports as Ethernet Pass-through (Optional) To revert Ethernet Pass-through to FC ports Additional resources	A Dell Deployment and Configuration GuideDell Networking S5000Switch Configuration Guide for SC Series iSCSI SANsDell Storage EngineeringFebruary 2016 Next / 12