Dell EqualLogic PS Series Setting Up

Also see for EqualLogic PS Series: Installation and setup Hardware maintenance Hardware owner's manual Installation and setup manual Hardware owner's manual

Connect the Power CablesUse the power cables shipped with the array to connect each power supply and cooling module to separate sources ofpower, if possible. Use the hook and loop fastener to secure the power cables to the power supply modules so theycannot be pulled out accidentally.See the Installation and Setup manual for more information.If the array was not shipped with power cables, see your PS Series support provider or reseller for power cableinformation.1Unpack the Shipping BoxProtect sensitive hardware. Make sure you use an electrostaticwrist strap or similar form of protection when handling hardware.Make sure the shipping box contains the following items:1. Setup poster (this document)2. Rail kit (if ordered)3. Accessory box, which includes:- All power cables- Electrostatic wrist strap- Translated documentation- Translation CD-ROM4. Documentation5. PS4100 chassis2Install the Array in a RackMount the array in a four-post, 19-inch rack. See the rack instructions that camewith the rail kit in your shipping box (if ordered).The array is heavy. Do not attempt to lift the array without assistance.Install the Front Bezel1. Hold the bezel with the array model number upright.2. Hook the right end of the bezel onto the right side of the chassis.3. Swing the left end of the bezel towards the left side of the chassis.4. Press the bezel into place until the release latch closes.5. Using the provided key, lock the front bezel. Store the key in a safe place.34PS Series Storage ArraysPS4100 InstallationBefore You BeginThis is a condensed reference. Read the safety instructions in your Safety, Environmental, and Regulatory Information booklet before youbegin. Also read the Installation and Setup manual for complete installation information.Register for an EqualLogic Customer Support account.If you do not have a customer service support account, go to support.dell.com and create one.Download and read the Release Notes from the support site.The PS Series Release Notes contain the latest product information.Environmental Requirements.Make sure the installation location meets the power, cooling, and ventilation requirements in the Installation and Setup manual, located in theshipping box.Networking Requirements.Standard Ethernet and TCP/IP networking rules apply to a PS Series SAN. Gigabit Ethernet is recommended for optimal performance.Required Hardware (not supplied)• Standard 19-inch, four-post rack.• One to four network cables. Supported cables include Category 5E and Category 6 cables with RJ45 connectors. Use Category 5 cablesonly if they meet the TIA/EIA TSB95 standard.Setting Up a PS Series Storage ArrayPS SERIES STORAGE ARRAYSInstallation & Setup ManualStep 4: Start Using the SANStep 3: Run the Remote Setup WizardSoftware Configuration MethodsPS Series Storage ArraysSoftware ConfigurationPS Series GroupsStep 1: Install the Host Integration ToolsStep 2: Collect Configuration InformationTo configure the PS Series software, you need the informationin the following tables.CHAP passwordGroup nameGroup IP addressMembershippasswordAdministrationpasswordCHAP user nameGroup ConfigurationRAID policyArray ConfigurationMember nameDefault gatewaySubnet maskArray IP addressRAID policyWhere to Go NextMulti-Member PS Series GroupGroup113245

/ 2

Related manuals for Dell EqualLogic PS Series