Datavideo HDR-100 Quich Start Manual

Contents

Datavideo HDR-100 Quich Start Manual Manual pdf 20 page image

19Playing a M2T TrackIt is playback M2T tracks to analogue monitors or recorders via the HD(YUV), HD-SDI or HDMI video outputs.Use the Previous (▲) / Next (▲) Button(right)s to select the track you want to play, and then press the Play (►II)Button.It is also possible to set the HDR-100 to loop play. In loop play the track will seamlessly looped until stopped.To set up loop play press the Menu Button to enter menu mode and then the FWD (►►) Button until SETUPLOOP PLAY is displayed.+Press the Next (▲) Button(right) to enter the setup loop play menu, and then press the FWD (►►) Button toselect ENABLEPress the Next (▲) Button(right) to select SET and then press the Menu Button to return to track display.When you press play the selected track will start playing, and will loop until the Stop (■) Button is pressed.To cancel loop playback, follow the above procedure but select disable instead of enable.Recording a trackTo record from an analogue video source you first need to set the analog input – see Video Input Source Menu formore details.Press the Video Input Button so that it is illuminated. You should see the video source on your output monitorUse the Next / Previous Buttons to select an empty track from the HDR-100 track list, one that shows a duration of00:00:00:00 in the LCD display.Not suitable - Trackhas been recordedSuitable - Track isemptyPress both the Record and Play/Pause Buttons simultaneously and the HDR-100 should start recording.+ The counter should start counting and the RECsymbol should appearIf it does not start recording check the following:There is an analogue video input present.The Video Input Button is illuminatedThe track you have selected on the HDR-100 is empty. The counter next to the TrackNo on the LCD display should bshowing 00:00:00:00.There is some available space on the HDR-100 Hard Disk - Go to the FREE SPACE Menu and check that the HDR-