USE AND FUNCTIONING6744.9.3 Updating the FirmwareAfter copying the firmware image to the host PC (see par. 4.10.1) and installing DFU(see par. 4.8.2), you can upgrade the firmware on your Datalogic device.The following steps require that you have already established anActiveSync or Windows Mobile Device Center connection betweenthe host computer and the Datalogic device.NOTE1. Go to Start > Programs > Datalogic > DFU > Datalogic Firmware Utility.2. Verify that ActiveSync is selected by clicking Communications > WMDC/ActiveSync.3. Click browse (...) and navigate to the location where you saved the firmwarefile for your terminal.4. Select the current *.out file and click Open.5. Click Update.6. DFU will compare the selected firmware image with the firmware alreadyloaded on the device; if the image is compatible with the connected device,DFU will proceed to update the firmware image on your device.After the firmware of your device has been updated, DFU will automaticallyperform a warm reset of the device.
