Danfoss AK-LM 330 Design Manual

Also see for AK-LM 330: User guide

Contents

Danfoss AK-LM 330 Design Manual Manual pdf 55 page image

AK-LM 330 RS8FR302 © Danfoss 2015-08 55Check of settings1.Go to the overview2. Select thermostats3. Overview for thermostats4. Move on with settings for thermostat 1!Before the control starts, we check that all the settings are as they shouldbe.The overview display will now show one line for each of the generalfunctions. Behind each icon there is a number of displays with thedifferent settings. It is all these settings that have to be checked.Remember the settings at the bottom of the pages – the ones that canonly be seen via the ”Scroll bar”.”!When this function is set to 'YES', a relay will be reserved which coupleswith the thermostat. Definition of the connection point must be doneduring the I/O configuration.(In our example, the setting is NO in Thermostats 1 and 2. And YES inThermostat 3).The two DI inputs are used if the thermostat's alarm function is to bechanged temporarily during daily operation:• Defrosting signal. Signal on the DI input entails change to Delay Time 2.• Alarm stop. Signal on the DI input stops alarms.(In our example, both settings have been used in Thermostat 2. Here thesettings are DI1 and DI2 respectively).