Dacor HDPR30S Installation Instructions And Owner's Manual

Also see for HDER30S: Installation instructions User manual User manual

Dacor HDPR30S Installation Instructions And Owner's Manual Manual pdf 17 page image

17EnglishInstallation RequirementsLocation RequirementsGas/Electrical Range Hookups (HDPRS/HDERS 30”, 36”, 48”)Gas/Electrical Service Inlets• Existing utilities may be used if compatible with the requirements in this manual. (See building codes forallowed gas-valve locations.)• An external shut-off valve must be installed between the gas inlet and range so its gas supply can be turnedon/off.• The valve and the circuit-breaker panel/fuse box must be accessible without moving the range.• The gas-supply piping, shut-off valve, and the electrical junction box/receptacle must not interfere with theplacement requirements for the range.• The junction box and gas-shut off valve must be located so the range can be pulled out for service withoutbeing disconnected.GAS-/ELECTRICAL-ACCESS DIMENSIONSModel A B* C D* E**HDPR30S/HDER30S 3 ¼" (8.3 cm) 27” (68.6 cm) 6 3/4" (17.1 cm)6 3/4 (17.1 cm) 7/8” (2.2 cm) dia.HDPR36S/HDER36S 6 3/4" (17.1 cm) 27” (68.6 cm) 12” (30.5 cm)HDPR48S/HDER48S 4 ¼” (10.8 cm) 27” (68.6 cm) 9” (22.9 cm)*Measurement with range legs adjusted to their lowest height; **the hole size for the electrical wiring may be increased to 1 1/8” (2.9cm) by removing the conduit bracket in the bottom of the electrical box.48” model shown