9Installation InstructionsInstalling the RangePeel the protective plastic coating off of the range,1.including the range door.Uncoil the power cord and route it to the electrical outlet2.so that it does not become trapped behind the rangewhen it is pushed back. Do not connect the power pluguntil you are ready to verify proper operation.Carefully slide the range into position in the cutout3.taking the slack out of the power cord as you push theunit into place. Be careful not to kink the power cord orgas line as you push the unit back. The rear anti-tip legshould engage the anti-tip bracket as you slide it back.Re-Installing the DoorWARNINGTo avoid personal injury or damage to the door from itfalling off its hinges:Make sure that the notch on the bottom of each hinge•rests on top of the lower lip of each hinge receptaclebefore attempting to open the oven door.Rotate the hinge locks toward the front of the range•immediately after installation of the door.Grasp the oven door on opposite sides and hold it at a1.15° angle from the front of the oven. Slide the hingesinto the hinge openings, resting the bottom of the hingearms on the hinge receptacles.Continue to hold the door at a 15° angle with one hand2.while pushing in on each of the bottom corners of thedoor. Push until the notch on the bottom of each hingeslips over the lower lip of each hinge receptacle.Lower the door to the fully opened position.3.Rotate the two hinge locks toward the oven. Slowly and4.carefully open and close the door completely to ensurethat it is properly installed.Remove any packaging from inside the oven.5.Door InstallationLower lip of hingereceptacleNotch