Dacor Epicure EGR30 Installation Instructions Manual

Also see for Epicure EGR30: Use and care manual Planning guide Use and care manual Cooking guide Installation instructions

Contents

Dacor Epicure EGR30 Installation Instructions Manual Manual pdf 11 page image

Gas ConnectionIMPORTANT: The gas pressure regulator is pre-set at the factoryfor the type of gas intended for use with the appliance. Verifythat the appliance is compatible with the type of gas availableby checking the data plate located behind the inlet air coolinggrill. Open the oven door and remove the inlet air cooling grill foraccess to the data plate. Ranges intended for use with LP gaseswilt have "LP" as a part of the model number. Consult your dealerif the range is not compatible with your gas supply.Gas Line InstallationBefore sliding the range into the cabinet, connect a flexible gasconnector to the gas shut-off valve previously installed on the stubout. The gas valve must be turned off during installation. Connectthe flex connector to the pipe fitting at the rear of the range.Installing the RangeInstallation of Self-Rimming Configuration(Models ERD30 and EGR30 only)1. Measure the distance from the floor to the countertop. Adjustthe leveling legs to position the bottom edge of the range topframe approximately 1/8" above the level of the countertop toallow the range to slide over it.2. Attach the anti-tip leveler to the range as shown below, if it isnot already attached. Lower the ant-tip leveler until it is 3/16"off the floor so that it will engage the anti-tip bracket when therange is pushed into its final position.3. Carefully slide the range into position in the cutout. The rearanti-tip leg should engage the anti-tip bracket.4. Lower the range onto the countertop by turning the levelinglegs counterclockwise. Lower the range until the bottom ofthe range top just contacts the countertop. Do not allow thefull weight of the range to hang on the counter.Installation of Free-Standing Configurations1. Measure from the floor to the countertop and adjust theleveling legs as required to position the top frame atthe desired height based on the cabinet and countertopinstallation.2. On models ERD30 and EGR30, attach the anti-tip leveler tothe range as shown below if it is not already attached. Lowerthe ant-tip leveler until it is 1/16" off the floor so that it wiltengage the anti-tip bracket when the range is pushed into itsfinal position.3. Carefully slide the range into position in the cutout. Onmodels ERD30 and EGR30, the rear anti-tip leg shouldengage the anti-tip bracket.Rear<Leveler __5/16 - 18 x 2or Equivalent\4./JILeftRearLegLocation Anti-Tip Leveler (Models ERD30 and EGR30 Only)_acar 9