Dacor EF42BDCB Planning Manual

Also see for EF42BDCB: Instruction sheet

Dacor EF42BDCB Planning Manual Manual pdf 1 page image

PLANNINGGUIDEWeb: http://www.Dacor.comCorporate Phone: 800-793-0093Specifications are subject to change without notice.See installation instructions for additional details. 11.242” & 48” widebuilt-In refrigeratorEf42bDCb, Ef42bNDb, If42bDCb, If42bNDb,Ef48bDCb, Ef48bNDb, If48bDCb, If48bNDb112905 1/3Model Rough-In Width “A”42-Inch 41 1/2”” (1054mm)48-Inch 47 1/2”” (1207mm)D oor swinG DimEnsionsThe area to the left and the right of the appliance must permitboth doors to open to a minimum of 90°. Allow a minimum of 21/2” (64mm) space between the side of the refrigerator doors anda corner wall.NOTE: More clearance may be required if using an overlay panelor custom handles.proDuct DimEnsions◊ The depth from the front of the top grill (w/o decorator panel)to the back of the refrigerator chassis is 25 1/4” (641mm).◊ The depth from the rear of the top grill to the back of therefrigerator chassis is 23 13/16” (605mm).◊ The power cord is 40” (1016mm) long.◊ The height from the top of the top grill to floor with theleveling legs in the down position is 83 3/8” (2118mm)◊ The height from the top of the top grill to floor with theleveling legs in the fully extended position is 84 5/8”(2149mm)◊ The chassis width from the chassis edge to the chassis edgefor 42-inch is model 41 1/4” (1048mm), 48-inch is model 471/4” (1200mm).◊ The overall width from the trim edge to the trim edge for 42-inch model is 42 1/16” (1068mm), 48-inch model is 48 1/16”(1221mm).ElEctrical rEquirEmEntsA 115VAC, 60 Hz, 15 Amp circuit breaker and electrical supply arerequired. A separate dedicated non-GFCI circuit, servicing onlythis appliance, is required.Your Dacor ® Built-In refrigerator is equipped with a 40” (1016mm)3-prong grounded power cord, which must be plugged into a3-prong grounding-type non-GFCI wall receptacle. Follow theNational Electrical Code and local codes and ordinances wheninstalling the receptacle. See “Rough-In Dimensions” for locationof the electrical supply.IMPORTANT: A ground fault circuit interrupter (GFCI) is notrecommended and may cause interruption of operation.◊ All installations must meet local plumbing coderequirements.◊ Connect to 1/4” (6mm) copper line to the house cold freshwater supply.◊ Use a shut off valve between the refrigerator and supply.The shut off valve should be a drilled saddle valve.◊ Do not use a self-tapping valve which reduces water flowand clogs more easily.◊ Route the water line within 3-1/2” (89mm) of the rear walland no higher than 3” (76mm) from the floor.◊ Allow a minimum of 24” (610mm) dimeter service loop ofcopper tubing outside the wall or floor for easy connection tothe water supply.Cold water supplyConnect the ice maker to a cold water line with water pressurebetween 30 and 120 PSI. If you have any questions about yourwater pressure, call your utility company.IMPORTANT:◊ In homes with a Reverse Osmosis water treatment system,remove the water inlet connector from the “yellow” valveand attached to the “blue” valve. Make sure the water filterbypass plug is in place.watEr supply rEquirEmEnts7”4”2”6”3”75 1/2”“A”83 3/4”Water SupplyElectrical24”

/ 3

Related manuals for Dacor EF42BDCB