2Planning the InstallationLocation RequirementsOperating EnvironmentDo not install this appliance where it is hit by direct sunlight or◊near a stove, range top, radiator or similar heat source.The appliance is set to operate within the room temperature◊limits listed below. These temperature limits should not beexceeded.ROOM TEMPERATURE REqUIREMENTSFOR PROPER OPERATION61°F to 90°F (16°C to 32°C)Location and Cabinet Layout RequirementsThe Dacor wine cooler or beverage center can be recessed in anopening between cabinets or installed at the end of a cabinet runusing a side panel to enclose it.IMPORTANT:The installation◊ location should permit the door to open aminimum of 90°. The maximum angle the door can open is105°.The appliance must be l◊ ocated so that the grill on the bottomis not obstructed.The electrical outlet must be accessible after installation so◊that the user can unplug the appliance.T◊ he floor under the appliance must be flat and level with thesurrounding floor.NOTE: The overall height of the appliance can be increased by1 ⅛” (28.6mm) by adjusting the feet. The cutout dimensions allowfor additional clearance for sliding the appliance into its recessbased on how you chose the final installation to look.Cabinet Cutout and Product DimensionsWARNINGIMPORTANT: Observe all governing codes and ordinancesduring planning and installation.Electrical RequirementsWARNINGIMPORTANT - This appliance is equipped with a three pronggrounding plug for your protection against possible electricshock hazards. Plug it only into a dedicated, grounded threeprong electrical outlet. It is the responsibility of the customer tomake sure the proper type of outlet is installed. Do not underany circumstances:Cut or remove the third (ground) prong from the power cord.•Use an adapter plug.•Use an extension cord.•Use a power cord that is frayed or damaged.•This ap◊ pliance should have its own separate, 110-120 Vac,15 Amp. grounded circuit controlled by a circuit breaker orfuse. Follow the National Electrical Code and local codes andordinances when installing the electrical outlet.The electrical outlet◊ must accept a grounded three prongpower cord. A ground fault circuit interrupter (GFCI) typeis not recommended because it may cause interruptionof operation. See Location Requirements for guidelinesregarding location of the electrical outlet.This appliance complies with current safety regulations and◊EC directives 73/23/EEC and 89/336/EEC.In addition, this appliance complies with UL250 and is◊designed to cool and store wine and beverages.The refrigerant system on this appliance has been tested for◊leaks.Power supply cord withthree prong grounding plugGrounded type electrical outlet(GFI not recommended)