Dacor DWD30 Use And Care Manual

Also see for DWD30: Installation instructions Use and care manual Installation instructions Use and care manual Planning guide

Contents

Dacor DWD30 Use And Care Manual Manual pdf 8 page image

6Care and Cleaningcaution• to prevent permanent damage to the appliancesurfaces, do not use abrasive cleaners or scrubbers.• Do not allow acids (citrus juices, tomato sauces,etc.) to remain on the warming drawer’s surfaces.the finish may stain.• Do not try to remove heavy spills with a sharp objectsuch as a knife or metal spatula. Sharp objects mayscratch the surfaces.• always wipe stainless steel surfaces in the directionof the grain.Control PanelClean the control panel with a soft cloth soaked with asolution of mild detergent and hot water. rinse and drywith a soft cloth. exercise caution to avoid introduction ofliquids into the area behind the control panel. Do not useabrasive cleaners or scrubbers. they may permanentlydamage the finish or scrap off the letters and graphics.Moist • Crisp ControlClean the Moist • Crisp lever with a solution of mild deter-gent and hot water. rinse and dry with a soft cloth.Drawer HandleClean the drawer handle with a solution of mild detergentand hot water. rinse and dry with a soft cloth.You may also use Dacor Stainless Steel Cleaner. It isavailable from your Dacor dealer. use it according to thedirections on the package.always wipe stainless steel surfaces in the direction of thegrain.Glass SurfacesClean all glass surfaces with a solution of mild detergentand hot water. You may also use a mild glass cleaner toremove fingerprints or smears. Dry completely with a soft,lint-free cloth.Brass and Chrome SurfacesClean brass and chrome surfaces with a solution of milddetergent and warm water. rinse, dry and polish with asoft, lint-free cloth.You may also use Dacor Stainless Steel Cleaner. It isavailable from your Dacor dealer. use it according to thedirections on the package.Painted Surfacesfor the front face of warming drawers with a paintedfinish, clean with a solution of mild detergent and hotwater. rinse and dry with a soft cloth. Do not use abrasivecleaners or scrubbers. they may permanently damage thefinish.Gasketthe gasket is located around the edge of the draweropening, below the control panel.Gently clean the gasket with a solution of mild detergentand hot water. rinse and dry with a soft cloth. the gasketmaterial is soft, so be careful not to crush or damageit. Damaging the gasket will cause a poor heat seal andresult in poor warming drawer performance.Drawer Slidesthe warming drawer has slides positioned on each sideof the drawer. they allow the drawer to slide in and outsmoothly. remove the drawer from the slides to makecleaning easy or to access the serial number plate. thedrawer slides themselves do not require maintenance.Removing the Drawer from theApplianceallow the drawer to cool before attempting to remove it.1. pull the drawer out to the fully open position.2. push in on the locking tab on one side as you pull thedrawer up. See the facing page.3. When the drawer comes loose from the slide, repeatthe same process on the opposite side.4. Grip the drawer on both sides and pull it free.5. for safety, push both drawer slides into the draweropening.Reinstalling The Drawer1. pull the drawer slides all the way out of the draweropening.2. Gently lower the drawer between the extended slidesuntil it is suspended by them.3. Slide the back of the drawer mounting brackets underthe clips on the slides. See the facing page.4. push one side of the drawer down onto its locking tab,until the tab locks into place.5. repeat the same process on the opposite side.6. Gently open and close the drawer to make sure that itis properly installed.