1For DACOR Built-in Kit Models AOMTK27 or AOMTK30THIS KIT IS UL APPROVED TO ALLOW CERTAIN MICROWAVE OVENS TO BE INSTALLED ABOVE CERTAIN CONVENTIONAL/CONVECTION WALLOVENS. PLEASE SEE THE OPERATION MANUAL REGARDING APPROVED BUILT-IN APPLICATIONS.IF YOUR LOWER CONVENTIONAL OVEN IS NOT LISTED IN THE OPERATION MANUAL OR INSTALLATIN INSTRUCTIONS OF THE MICROWAVE OVENAS AN APPROVED MAKE AND MODEL, THEN DO NOT INSTALL THE MICROWAVE OVEN IN ANY AREA WHERE HEAT AND STEAM ARE GENERATED;FOR EXAMPLE, NEXT TO OR ABOVE A CONVENTIONAL RANGE OR ABOVE A CONVENTIONAL WALL OVEN.I N S T A L L A T I O N I N S T R U C T I O N SSCREW A - QTY 2 SCREW B - QTY 4Lower Oven: EO127, EO130, MOV127, MOH127, MOV130, MOH130, PO127, PO130Do not build-in above any other gas or electric wall oven.IMPORTANT :This Built-in Kit is designed for and approved only for those DACOR Microwave Ovens specifying Built-In Kit AOMTK27or AOMTK30 on the rating label on the left side wall of the oven cavity.The cabinet or wall opening must be within the following dimensions:HEIGHT : 16HEIGHT : 16 3/3/3 4/4/ " to 17"WIDTH : 24 3/3/3 8/8/ " to 24 11/16"DEPTH : minimum 20"DEPTH : minimum 20"PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION!• Be sure to DISCONNECT THE PLUG of the microwave oven from the electrical outlet before installing the Built-in Kit.Remove the turntable from the oven cavity.• Because the kit includes metal parts, due caution should be used in handling and installation to avoid the possibility ofinjury.1 23 4FRAME ASSEMBLY - QTY 1 EXHAUST DUCT ASSEMBLY - QTY 1