Menu
DABIR MP Surface Installation Manual
  |
Corporate Headquarters, Sales & Manufacturing:Dabir Surfaces, Inc., 7447 West Wilson Ave., Harwood Heights, IL 60706, USA, www.dabir-surfaces.comSales Inquiries: sales@dabir-surfaces.com, Tel: +1(888)559-3641Technical Support: support@dabir-surfaces.com, Tel: +1(888)559-3642DOC# R02-0006-00054-CA1WARNINGS / CAUTIONS:• Surfaces are intended to be used ABOVE an underlying bed mattresswith good pressure redistribution properties over the full patient contact area.• Always place the Surface ABOVE the mattress and cover it with a bed linen.• Surfaces are NOT intended to be used in direct contact with the patient’s skin.• It is the responsibility of the user to secure and protect against patient movement and/or falls.• Therapy is NOT provided unless the Controller is powered “ON” and the Surface is actively cycling.• To avoid depressurization noise, do NOT unplug Surface connector while System is activated.• It is the responsibility of the user to properly clean and disinfect the System prior to patient use.®Surface Installation Guide (D2 Models Only)Surface Installation1. Place Dabir Surface onto flat mattress with “THIS SIDE UP” facing up (gray side down) and secure optional corner straps whenapplicable. (Surface should lay flat when properly installed.) Hose exit orientation is optional depending on the desired set-up.2. Place facility supplied linen and incontinence pad(s) over the top of the Dabir Surface and tuck edges underneath the mattress.Avoid wrinkles whenever possible to optimize Dabir performance and patient comfort.Bed Installation DiagramSTEPS 1 & 2: Bed InstallationDabir Surface(Gray Side Down)SurfaceConnectorSTEPS 3 & 4: Connector InsertionImportant Before You Start: THIS IS A “QUICK SET-UP” GUIDE ONLYPlease refer to the Dabir Operation / Service Technical Manual for full set-up and usage instructions. Failure to carefully read andfollow all instructions and safety information may result in decreased product performance or injury.System Installation - Surface Connections3. Insert Surface connector as shown.4. Listen for an insertion “CLICK” to confirm proper connection.NOTE: Therapy will start automatically if powered “ON”.Linen or Fitted SheetDabir Surface(Gray side down)Incontinence PadMattress with good pressureredistribution properties |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved