194 © 2001- 2006 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.D-Link Unified Access System User Manual10. Enter CTRL + Z to exit to Privileged EXEC mode and view the network configuration tomake sure the L3 Tunnel Status is listed as “Configured” and to confirm that othernetwork settings are correct.(switch-prompt) #show wireless network 3Network ID..................................... 3SSID........................................... L3 TunnelDefault VLAN................................... 1Hide SSID...................................... DisableDeny Broadcast................................. DisableL3 Tunnel Mode................................. EnableL3 Tunnel Status............................... ConfiguredL3 Tunnel Subnet IP............................ 192.168.60.0L3 Tunnel Subnet Mask.......................... 255.255.255.0Security Mode.................................. WPA EnterpriseMAC Authentication............................. DisableRADIUS Use AP Profile.......................... EnableRADIUS Server IP............................... 0.0.0.0RADIUS Secret Configured....................... NoRADIUS Accounting.............................. DisableWPA Versions................................... WPA/WPA2WPA Ciphers.................................... TKIPWPA Key Type................................... ASCIIWPA Key........................................WPA2 Pre-Authentication........................ EnableWPA2 Pre-Authentication Limit (minutes)........ 0WPA2 Pre-Authentication Timeout (minutes)...... 0--More-- or (q)uitWPA2 Key Forwarding............................ EnableWPA2 Key Caching Holdtime (minutes)............ 10WEP Authentication Type........................ Open SystemWEP Key Type................................... HEXWEP Key Length (bits).......................... 128WEP Transfer Key Index......................... 1WEP Key 1......................................WEP Key 2......................................WEP Key 3......................................WEP Key 4......................................An important value to note is the L3 Tunnel Status value. The following table lists thepossible values and explains what they mean.Table 63. L3 Tunnel Status ValuesL3 Tunnel Status DescriptionNone The status might be None for one of the following reasons:• The WLAN Operational Status is disabled• L3 Tunnel is Disabled• The network is not associated with any AP profiles. If you createor edit a network and configure L3 Tunneling, but there are noVAPs on any AP Profiles that use the network, the status is None.Configured The L3 Tunnel is configured and ready to be applied to the APs thatuse this profile.
