D-Link Express Ethernetwork DI-704P User Manual

Also see for Express Ethernetwork DI-704P: Brochure Brochure Brochure Datasheet Owner's manual

Contents

11Network SetupTurn everything off.A. Power OFF your Cable or DSL modem. If you modem doesnot have an on/off switch, disconnect the power cable.B. Turn OFF your computer.C. Do NOT connect the power adapter to your D-Link router.Connect the D-Link Router Cables.A. Connect the Ethernet (or networking) cable from the Cable orDSL modem to the WAN port of the router.B. Use the D-Link supplied Ethernet cable to connect the Ethernetport (Network Card) of your computer to one of the LAN ports ofthe router. The complete setup should look like Fig.1 shown above.Power up the devices in sequence.A. Power up the Cable or DSL modem. Wait until the modem hasmade the connection to your Internet Service Prover’s (ISP’s)network.B. Power up the D-Link router by connecting the D-Link providedpower adapter to the router and to an available power outlet.C. Turn on your computer.D. Now, refer to either the Quick Installation Guide or continueto follow this manual to complete the installation process.Note: Please see the Manual included with your modem for an explanation ofthe modem’s LEDs.