| 
D-Link Unified Access Point CLI Reference Manual14 © 2001- 2009 D-Link Corporation. All Rights ReservedS TATUSUse the commands in this section to view various AP status information.Set the password set system password Example:set system password test1234Set the baud rate for the serial port set serial baud-rateSet the system name set system system-name Example:set system system-name "AEO AP"Set the system location set system system-location Set the administrator’s contact information set system system-contact Note: Make sure you are familiar with the names of the interfaces as described in “Interface Naming Conventions”on page 11. The interface name you reference in a get command determines whether the command output showsa wired or wireless interface, the Internal network, or to radio “one” or radio two.”Table 6: Status CommandsActionCommandGlobal command to get all detail on a Basic Service Set (BSS).This is a useful command to use to get a comprehensive picture of howthe AP is currently configured.get bss all detailGet information about the wired and WLAN interfaces get interfaceGet the MAC Address for the Wired Internal Interface get interface wlan0 macGet the VLAN ID for the wired interface get management vlan-idGet the Network Name (SSID) for the default virtual access point. get interface wlan0 ssidGet the Current IEEE 802.11 Radio Mode get radio wlan0 modeGet the Channel the AP is Currently Using get radio wlan0 channelGet Basic Radio Settings for the Internal Interface get radio wlan0get radio wlan0 detailGet Client Associations get association detailGet neighboring access points get detected-ap detailGet information about switches that can discover and manage the AP get managed-apTable 5: Basic Setting Commands (Cont.)ActionCommandReview Copy |
