D-Link DES-3010G Command Line Interface Reference Manual

DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual1I NTRODUCTIONThis document is a reference guide for all DES-3010F/DES-3010G/DES-3018/DES-3026 switches. Throughout this manual, theDES-3026 Switch will be the Switch referred to for all examples and configuration information. All DES-3010F/DES-3010G/DES-3018/DES-3026 switches contain the same information and posses the same configuration capabilities. Thedifference in switches reside in the port type and the port count only.The DES-3026 Switch can be managed through the Switch’s serial port, Telnet, or the Web-based management agent. TheCommand Line Interface (CLI) can be used to configure and manage the Switch via the serial port or Telnet interfaces.This manual provides a reference for all of the commands contained in the CLI. Configuration and management of the Switchvia the Web-based management agent is discussed in the User’s Guide.Accessing the Switch via the Serial PortThe Switch’s serial port’s default settings are as follows:• 9600 baud• no parity• 8 data bits• 1 stop bitA computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured asabove is then connected to the Switch’s serial port via an RS-232 DB-9 cable.With the serial port properly connected to a management computer, the following screen should be visible. If this screen doesnot appear, try pressing Ctrl+r to refresh the console screen.Figure 1-1. Initial CLI screen1