D-Link DCM-712 Quick Installation Manual

Also see for DCM-712: Quick install guide

DCM-712 VoIP Cable Modem Quick Installation GuideUnpacking and Inspection DCM-712 cable modem * 1 RJ-45 CAT 5e cable * 1 15 V/1.0A Power Adaptor * 1 QIG * 1Rear Panel and Hardware ConnectionThis chapter describes the proper steps for connecting your cable modem. Please be sure to followthe steps in the sequence outlined below. Failure to do so could result in improper operation or failureof your cable modem.Step 1:Connect a cable by feeding the F-connector on the back of the cable modem. Ensure the centerconductor of the 75 ohm coaxial cable is inserted directly into the center of the F-connector. Securethe coaxial cable by carefully threading the outer shell of the coaxial cable connector onto theF-connector in a clockwise direction until tight. Be careful not to over-tighten the connector or you maydamage either the connector or the cable modem.Step2: Connect the cable modem to an IEEE 802.3 10/100/1000Base-TX Network using a RJ-45male-terminated Ethernet cable. This cable modem equips with one Ethernet ports.Step 3: Connect the telephone sets to TEL1 and TEL2. Use RJ-11 telephone line to connectTEL1/TEL2 port on the cable modem and telephone socket on telephone.Step 1 Connectingthe Coaxial CableStep 3 Connecting theTelephone cordStep 4 Connecting tothe AC AdapterStep 2 Connecting to a NetworkInterface CardPower On / OffAll manuals and user guides at all-guides.comall-guides.com

/ 5

Related manuals for D-Link DCM-712