Menu
D-Link DCH-122 Manual
         |
DCH-122 PIR Motion SensorThe DCH-122 has PIR motion sensor function in one, based on Z-WaveTM technology.It is the Z-WaveTM plus product, it support the security, ... Thosenewest features of the Z-WaveTM technology. Z-WaveTM is a wirelesscommunication protocol designed for home automation, specifically toremotely control applications in residential and light commercialenvironments. The technology uses a low-power RF radio embedded orretrofitted into home electronics devices and systems, such as lighting,home access control, entertainment systems and household appliances.This product can be included and operated in any Z-WaveTM networkwith other Z-WaveTM certified devices from other manufacturers and/orother applications. All non-battery operated nodes within the networkwill act as repeaters regardless of vendor to increase reliability of thenetwork.The device adopt the Z-WaveTM 500 series chip, when your Z-WaveTMnetwork system is all made by Z-WaveTM 500 series devices. Thenetwork system will have the advantages as below.• Concurrent multi-channel support reduces external interference.• Better RF range, improve about 10 meters in indoor.• Support 100 Kbps transmit speed, speed up communication.Add to/Remove from Z-WaveTM NetworkThere are two tamper keys in the device, one is in the back side,another is in the front side. Both of them can add, remove, reset orassociation from Z-WaveTM network.In the first time, add the device into the Z-WaveTM network. First,make sure the primary controller is in the add mode. And then poweron the device, just take out the insulation Mylar in the back side of thedevice. The device will auto start the NWI (Network Wide Inclusion)mode. And it should be included in 5 seconds. You will see the LEDlight ON one second.Notice: Including a node ID allocated by Z-WaveTM Controller means“Add” or “Inclusion”. Excluding a node ID allocated by Z-WaveTMController means “Remove” or “Exclusion”.Function DescriptionAdd1. Have Z-WaveTM Controller entered inclusion mode.2. Pressing tamper key three times within 1.5 secondsto enter the inclusion mode.3. After add successful, the device will wake toreceive the setting command from Z-WaveTMController about 20 seconds.1All manuals and user guides at all-guides.comall-guides.com |
Related manuals for D-Link DCH-122
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved